Contrôle d'accès

VERTX CS V300

Extrait Notice technique

70300

VertX? V300 Output
Control Interface
Output Control Processing for up to 12 Devices
The HID VertX products provide a complete and fully
featured hardware/firmware infrastructure for access
control software host systems. The V300 output control
interface contains 12 latching Form-C relays, which can
connect up to 12 devices controllable by simple contact
closures, such as logic inputs for process equipment, HVAC
and elevator control panels, CCTV switchers, etc. Loads
exceeding 2 A @ 30 VDC should be controlled via
interposing relays.
The V300 features on-board flash memory, allowing
program updates to be downloaded via the network. The
V300 connects to the V1000 through a high speed RS-485
network. The V1000 communicates with the system host
via industry standard TCP/IP protocol over 10/100 Mbps
Ethernet or the Internet. This architecture minimizes the
impact on corporate LANs, by using only one TCP/IP
address for every 32 Interfaces, and by handling low-level
transactions on the RS-485 network.

Features

.55 mm)
4.825? (122

? Off-normal status programmable for each input point
(NO or NC alarm devices may be used).
? 12 latching Form-C relays, contacts rated at 2A @ 30VDC.
? Connects to the V1000 via RS-485.
? Receives and processes real time
commands from the V1000.
? Reports all activity to the V1000.
? Allows complex input/output linking when
used with the V1000 and V200.
? Attractive polycarbonate enclosure protects
components from damage.
? All connections and indicators are fully
identified by silk-screened nomenclature on
the cover.
? UL 294 and UL 1076 recognized component.

5.8? (147.32 mm)

VertX? V300 12-Output Relay Control Unit
Features

Specifications

Mounting
Mount to any wall surface, using four screws. For UL
compliance, one or more interfaces can be mounted
inside a locking customer-supplied NEMA-4 rated enclosure
with:
? DC supply with battery back-up
? Enclosure tamper switch
? All connections made through conduit
The unit should be installed indoors, inside a secure
area, such as in an IT or telecommunications room,
utility closet, or on a wall above a suspended ceiling.

Dimensions
5.8? W x 4.825? H x 1.275? D
(147.32 mm x 122.55 mm x 32.38 mm)

Visual Indicators
Communications LED flashes green for ?transmit to
host? and red for ?receive from host.? Power LED
indicates that sufficient DC voltage is being provided
to the unit.
Easily Interfaced
? Quick-disconnect screw terminal connectors
? Rotary address switch (0-15)
? Latching form-C relay outputs for 12 relay
controllable devices
? Inputs for:
? 2 auxiliary input circuits
? AC Fail Monitor*
? Battery Fail Monitor*
? Enclosure Tamper*
*Can be configured as a general purpose input
Local Processing
? Basic input/output linking for outputs 1 and 2, and
auxiliary inputs 1 and 2
Microcontroller
Warranty
Warranted against defects in materials and workmanship
for 18 months. (See complete warranty policy for details.)

Specifications subject to change without notice.

Enclosure Material: UL94 Polycarbonate
Power Supply Requirements
60 mA @ 9-18 VDC
Recommended: supervised linear power supply
with battery backup, input surge protection, and
AC Fail and battery low contact outputs.
Separate supervised, DC supply with battery
back-up recommended for relay activated
devices.
Relay Rating
2 A @ 30 VDC maximum load
Operating Environment
Indoors, or customer-supplied NEMA-4 rated
enclosure
Temperature
32° to 122° F (0° to 50° C)
Humidity
5% to 95% relative, non-condensing
Communications Ports
RS-485: two wire.
Certifications
UL 294 and UL 1076 Recognized Component for the US
CSA 205 for Canada
FCC Class A Verification
EMC for Canada, EU (CE Mark), Australia (C-Tick Mark),
New Zealand, Japan
EN 50130-4 Access Control Systems Immunity for the
EU (CE Mark)

Cable Distance
RS-485 ? 4000 feet (1220 m) to host using
Belden 3105A, 22 AWG twisted pair, shielded
100? cable
Output Circuits ? 500 feet (150 m), 2-conductor,
using ALPHA 1172C (22AWG) or Alpha 1897C
(18AWG)
Minimum wire gauge depends on cable length
and current requirements.

Part Numbers
Base Part Number: 70300

www.hidcorp.com

Weight: 13.6 oz (.38 kg)

CORPORATE HEADQUARTERS:
HID Corporation
9292 Jeronimo Road
Irvine, CA 92618-1905 U.S.A.
PHONE +1 (949) 598-1600 or (800) 237-7769
FAX +1 (949) 598-1690

HID INTERNATIONAL:
Asia Pacific: +(852) 2530-9907
Europe: +44 (0) 1440 714 850

LITV300DSUS Rev. 12-04, ©2005 HID Corporation. All rights reserved.
HID, the HID logo, and VertX are trademarks or registered trademarks
of HID Corporation in the U.S., and/or other countries.